Disassembly and Reassembly

DISASSEMBLY

1. DISCONNECT FUEL PUMP CONNECTORS
2. DISCONNECT GROUND PLATE

3. REMOVE FUEL SENDER GAUGE
Push down the portion of A with a finger, and push up the sender gauge.

NOTE: Be careful that the arm of the sender gauge should not bent.

4. REMOVE FUEL FILTER




a. Remove the screw, and pull out the fuel filter.
b. Remove the O-ring from the fuel filter.

HINT: At the time of assembly, please refer to the following items Apply a light coat of gasoline to a new O-ring, and install it to the fuel filter.

Torque: 2.0 N.m (20 kgf.cm, 17 in.lbf)




5. REMOVE FUEL PUMP FLANGE
Using a screwdriver, remove the snap fit portion in the order of 1, 2 and 3 as shown in the illustration.

HINT:At the time of assembly, please refer to the following items. Apply a light coat of gasoline to a new O-ring of the fuel pump.




6. REMOVE READ WIRE




7. REMOVE "C" BRACKET, RUBBER CUSHION AND FUEL PUMP
Using a screwdriver, remove the snap fit portion in the order of 1, 2 and 3 as shown in the illustration.




8. REMOVE FUEL PUMP FILTER FROM FUEL PUMP
a. Using a small screwdriver, remove the clip.
b. Pull out the pump filter.

HINT: At the time of assembly, please refer to the following items.
Install the pump filter with a new clip.

REASSEMBLY
Reassembly is in the reverse order of disassembly.