Trunk / Liftgate: Service and Repair
DISASSEMBLY1. REMOVE BACK DOOR TRIM
a. Remove the assist strap hole cover, bolt and assist strap.
b. Using a screwdriver, remove the back door trim.
HINT: Tape the screwdriver tip before use.
2. REMOVE PLATE
a. Remove the 9 screws and plate.
b. Disconnect the connector.
3. REMOVE BACK DOOR GLASS RUN
4. REMOVE OUTER WEATHERSTRIP
5. REMOVE BACK DOOR GLASS
Remove the 6 bolts and door glass.
NOTE: Do not damage the door glass.
6. REMOVE WINDOW REGULATOR
Remove the window regulator mounting bolts.
Torque: 5.0 N.m (50 kgf.cm, 43 in.lbf)
7. REMOVE LH AND RH BACK DOOR GLASS GUIDE RAIL
Remove the 8 bolts and LH and RH back door glass guide rails.
Torque: 5.0 N.m (50 kgf.cm, 43 in.lbf)
8. REMOVE LOCK CONTROL BELLCRANK
Remove the 2 nuts and lock control bellcrank.
9. REMOVE BACK DOOR REMOTE CONTROL
10. REMOVE BACK DOOR GARNISH
a. Remove the nut.
b. Using a screwdriver, remove the back door garnish.
HINT: Tape the screwdriver tip before use.
11. REMOVE BACK DOOR LOCK CYLINDER
12. REMOVE BACK DOOR LOCK
Remove the 3 bolts and back door lock.
Torque: 7.0 N.m (70 kgf.cm, 61 in.lbf)
REASSEMBLY
Reassembly is in the reverse order of disassembly.