Speed Sensor, Front

REMOVAL
REMOVE SPEED SENSOR





a. Disconnect the speed sensor connector.
b. Remove the 4 resin clips and 3 clamp bolts holding the sensor harness from the steering knuckle, upper arm and side rail.
Torque:
Steering knuckle and upper arm: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
Side rail: 12 Nm (122 kgf-cm, 9 ft. lbs.)
c. Remove the speed sensor installation bolt from the steering knuckle.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)


INSTALLATION
Installation is in the reverse order of removal .
AFTER INSTALLATION, CHECK SPEED SENSOR SIGNAL

CAUTION:
^ There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be Installed.
^ The sensor is installed flat against the knuckle when you tighten the bolt.
^ When installing the resin clips, use new ones.