Speed Sensor, Rear

REMOVAL
REMOVE SPEED SENSOR





a. Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.
b. Remove the 5 resin clips, holding the sensor wire harness from the frame, upper control arm and axle housing.
c. Remove the mounting bolt and speed sensor.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)


INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, CHECK SPEED SENSOR SIGNAL

NOTICE: Make sure that
^ There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be installed.
^ The sensor is installed flat against the knuckle when you tighten the bolt.
^ When installing the resin clips, use new ones.