Blower Motor Switch: Testing and Inspection

1. REMOVE CENTER CLUSTER FINISH PANEL
Using a screwdriver, release the 4 claws and pull out the panel and disconnect the connectors.

HINT: Tape the screwdriver tip before use.




2. REMOVE REAR BLOWER SWITCH
a. Pull out the switch knob.
b. Remove the 2 screws and switch.




3. INSPECT REAR BLOWER SWITCH CONTINUITY




- Switch continuity:
If continuity is not as specified, replace the switch.
- Illumination circuit:
If continuity is not as specified, check the bulb.




4. INSTALL REAR BLOWER SWITCH
a. Install the switch with the 2 screws.
b. Install the switch knob.

5. INSTALL CENTER CLUSTER FINISH PANEL
Install the panel, then connect the connector.