Rear Side Window Glass(LH)
REMOVAL1. Except van:
REMOVE REAR N0.2 SEAT
2. 5-Door vehicle:
REMOVE SLIDE DOOR SCUFF PLATE
3. REMOVE BACK DOOR SCUFF PLATE
Using a screwdriver, remove the back door scuff plate.
HINT: Tape the screwdriver tip before use.
4. REMOVE REAR LH QUARTER TRIM PANEL
a. Using a screwdriver, remove the speaker grille.
HINT: Tape the screwdriver tip before use.
b. Remove the quarter trim cover.
c. Using a screwdriver, remove the rear side trim board cover.
HINT: Tape the screwdriver tip before use.
d. Remove the luggage room light, then disconnect the connector.
e. 5-Door vehicles:
Remove the slide door courtesy light, then disconnect the connector.
f. 4-Door vehicles:
Remove the 4 screws,clip and rear LH quarter trim panel.
g. 5-Door vehicles:
Remove the 2 screws, clip and rear LH quarter trim panel.
5. REMOVE N0.2 LH REAR WINDOW SIDE GARNISH
a. Using a screwdriver, remove the quarter pillar cover.
HINT: Tape the screwdriver tip before use.
b. Remove the 2 screws and No.2 LH rear window side garnish.
6. REMOVE LH REAR WINDOW SIDE GARNISH
a. w/ No.1 rear seat belt:
Remove the No.1 rear seat outer belt shoulder anchor.
Torque: 43 N.m (440 kgf.cm, 32 ft.lbf)
b. Remove the 2 clips and LH rear window side garnish.
7. w/ Power vent window:
REMOVE REAR SIDE WINDOW
a. Disconnect the power vent window motor connector.
b. Remove the clip, 2 bolts and power vent window motor.
c. Remove the 2 nuts and rear side window.
d. Remove the screw and quarter window lock hinge from the rear side window
8. w/o Power vent window:
REMOVE REAR SIDE WINDOW
a. Remove the 2 bolts, 2 nuts and rear side window.
b. Remove the screw and quarter window lock from the rear side window.
9. REMOVE REAR SIDE WINDOW WEATHERSTRIP
INSTALLATION
Installation is in the reverse order of removal.