Removal and Installation

Part 1 Of 2:

Part 2 Of 2:

REMOVAL
1. DRAIN HYPOID GEAR OIL
2. REMOVE REAR AXLE SHAFTS
3. DISCONNECT REAR PROPELLER SHAFT
4. REMOVE DIFFERENTIAL CARRIER ASSEMBLY
a. Remove the 10 nuts, washers and differential carrier assembly.

NOTICE: Be careful not to damage the installation surface.

Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
b. Remove the gasket.

INSTALLATION
Installation is in the reverse order of removal.

HINT: After installation, fill the differential with hypoid gear oil.