With SR5

INSPECTION








1. INSPECT 2-4 SELECTOR SWITCH CONTINUITY
If continuity is not as specified, replace the shift lever knob.





2. INSPECT ACTUATOR RESISTANCE
a. Using an ohmmeter, measure the resistance between terminals 2 and 3.
Standard resistance: 0.3 - 100 ohms
b. Using an ohmmeter, measure the resistance between terminals 2 or 3 and body ground.
Standard resistance: More than 0.5 M ohms
If resistance value is not as specified, replace the actuator assembly.
3. INSPECT ACTUATOR OPERATION





a. Connect lines via a relay as shown in the illustration, then check that the actuator fork shaft moves to 2WD position.








b. Connect lines via a relay as shown in the illustration, then check that the actuator fork shaft moves to 4WD position.

HINT: When inspecting the operation described above, use a heater main relay. If operation is not as specified, replace the actuator assembly.

4. INSPECT LIMIT SWITCH CONTINUITY





a. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 3.
b. Connect the positive (+) lead from the ohmmeter to terminal 5 and the negative (-) lead to terminal 4.
c. Check that there is continuity between terminals 4 and 5.





d. Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 2.
e. Connect the positive (+) lead from the ohmmeter to terminal 6 and the negative (-) lead to terminal 4.
f. Check that there is continuity between terminal 4 and 6. If continuity is not as specified, replace the actuator assembly.
5. INSPECT NO.1 VEHICLE SPEED SENSOR
6. INSPECT 4WD INDICATOR LAMP
Check the combination meter.





7. w/ One touch 2-4 selector system: INSPECT 4WD CONTROL ECU
Connect the wire harness side connector to the ECU and inspect wire harness side connector from the back side, as shown.

STANDARD VALUE OF ECU TERMINAL





Part 1 of 2





Part 2 of 2