Ignition Cable: Testing and Inspection

ON-VEHICLE INSPECTION

INSPECT HIGH-TENSION CORDS




a. Remove the air cleaner hose.
b. Disconnect the high-tension cords at the rubber boot. Do not pull on the high-tension cords.

NOTE: Pulling on or bending the cords may damage the conductor inside.




c. Using an ohmmeter, measure the high-tension cord resistance.

Maximum resistance: 25 kohms per cord

If the resistance is greater than maximum, check the terminals. If necessary, replace the high-tension cord.




d. Reconnect and install the high-tension cords as shown in the illustration.