Antitheft - Control Module New Location And Mounting
ACCESSORIESAX006-00
Title:
RS3000 TVIP ECU MOUNTING
Models:
'00 Tundra
July 7, 2000
Introduction
To improve mounting stability on 2000 MY Tundra vehicles equipped with a Post Production Option (PPO) or Dealer Installed Option (DIO); RS3000 TVIP, the location of the V3 ECU was changed from the left cluster panel to the vehicle instrument panel cross-member on the right side of the steering column. The mounting method has changed from butyl tape to a solid bracket screwed to the V3 ECU. Refer to the installation instructions for details on the installation.
Verification of the PPO and DIO RS3000 TVIP System can easily be performed by identifying the remote transmitter and status monitor.
Applicable Vehicles
^ All 2000 model year Tundra vehicles equipped with DIO or PPO RS3000 TVIP.
Parts Information
Warranty Information
Installation Instructions
These illustrations call out the change in location and new mounting method of the ECU.
Previous Method
The Previous method was to insert the V3 ECU into the dash through the left cluster panel opening and secure it to the plastic using butyl tape.
New Method
1. Prepare the V3 ECU as described in the installation instructions.
2. Remove the connector block mounted near the firewall to the right side of the steering column.
3. Connect the V3 harness ECU connectors (10P, 10p, 4P) to the V3 ECU.
4. With the connectors facing left, slide the ECU mounting bracket over the existing stud bolt, then secure it and the connector block with the previously removed nut.