Manual Seat
Side Airbag Assembly (Manual Adjuster Type):
COMPONENTS
REMOVAL
NOTE:
- If the wiring connector of the SRS is disconnected and the ignition switch is at ACC or ON position, DTCs will be recorded.
- Never use the airbag parts from another vehicle. When replacing parts, replace them with new parts.
1. REMOVE FRONT SEAT
a. Remove the 4 seat track covers and 4 bolts.
b. Disconnect the side airbag connector.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
c. Remove the front seat.
NOTE: Be careful not to damage the body.
2. REMOVE HEADREST
3. REMOVE RECLINING ADJUSTER RELEASE HANDLE
4. REMOVE FRONT SEAT CUSHION SHIELD
Remove the 2 screws and front seat cushion shield.
5. REMOVE FRONT SEAT CUSHION INNER SHIELD
Remove the 2 screws and front seat cushion inner shield.
6. REMOVE SEATBACK ASSEMBLY
a. Remove the 3 hog rings as shown in the illustration.
b. Remove the wire harness of side airbag assembly.
c. Remove the 4 bolts and seatback assembly.
INSTALLATION
NOTE: Never use airbag parts from another vehicle. When replacing parts, replace them with new parts.
1. INSTALL ARMREST
a. Install the armrest with the bolt.
Torque: 37 N.m (380 kg.cm, 27 ft.lb)
b. Close the fastener.
2. INSTALL SEATBACK ASSEMBLY
a. Install the 4 bolts.
Torque: 43 N.m (440 kg.cm, 32 ft.lb)
NOTE:
- Make sure that the seatback assembly is installed with the specified torque.
- If the seatback assembly has been dropped, or there are cracks, dents or other defects in the case or connector, replace the seatback assembly with a new one.
- When installing the seatback assembly, take care it is not pinched between other parts.
b. Install 3 new hog rings as shown in the illustration.
HINT: When installing new hog rings, take care to prevent wrinkles as much as possible.
c. Install the wire harness to the reclining adjuster inside cover.
3. INSTALL FRONT SEAT CUSHION INNER SHIELD
Install the front seat cushion inner shield with the 2 screws.
4. INSTALL FRONT SEAT CUSHION OUTER SHIELD
Install the front seat cushion outer shield with the 2 screws.
5. INSTALL RECLINING RELEASE LEVER
6. INSTALL HEADREST
7. INSTALL FRONT SEAT
a. Install the front seat.
NOTE: Be careful not to damage body.
b. Connect the side airbag connector.
c. Install the 4 seat track covers with the 4 bolts.
Torque: 37 N.m (380 kg.cm, 27 ft.lb)