Operation CHARM: Car repair manuals for everyone.

Removal and Installation

Front Airbag Sensor:




COMPONENTS

REMOVAL

NOTE:
- If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC position, DTCs will be recorded.
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the sensor involved in a collision when the SRS has deployed.
- Never repair a sensor in order to reuse it.




1. LH: REMOVE FRONT AIRBAG SENSOR
a. Remove the battery carrier, battery and battery tray.
b. Disconnect the front airbag sensor connector.

NOTE: Disconnect the connector with sensor assembly installed

c. Remove the 2 bolts and front airbag sensor LH.

2. RH: REMOVE FRONT AIRBAG SENSOR
a. Remove the air cleaner assembly.
b. Disconnect the front airbag sensor connector.

NOTE: Disconnect the connector with sensor assembly installed.

c. Remove the 2 bolts and front airbag sensor RH.

INSTALLATION







INSTALL FRONT AIRBAG SENSORS
a. Install the front airbag sensors with the 4 bolts.

Torque: 20 N.m (205 kg.cm, 15 ft.lb)

NOTE:
- Connection of the connector is done after the sensor has been installed.
- Make sure the sensor is installed with the specified torque.
- If the sensor has been dropped, or there are cracks, dents or other defects in the case, brackets or connector, replace the removed sensor with a new one.
- The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the connector. If the connector is not securely locked, a malfunction code will be detected by the diagnostic system.

HINT: Install the front airbag sensor with the arrow on the sensor facing toward the front of the vehicle.

b. Connect the front airbag sensor connectors.
c. Install the air cleaner assembly.
d. Install the battery tray, battery and battery carrier.