Input Shaft

INSPECTION
1. REMOVE 2 OIL SEAL RINGS
2. INSPECT INPUT SHAFT





a. Using a micrometer, measure the outer diameter of the input shaft journal surface.
Minimum diameter: 47.59 mm (1.8736 inch)
If the outer diameter is less than the minimum, replace the input shaft.





b. Using a dial indicator, measure the inside diameter of the input shaft bushing.
Maximum diameter: 39.14 mm (1.5409 inch)
If the inside diameter exceeds the maximum, replace the input shaft.





3. INSTALL 2 OIL SEAL RINGS

HINT:
- Apply gear oil to the oil seal ring.
- Hang securely to eliminate clearance.