Manual Adjuster

Front Seat (Manual Adjuster Type):

COMPONENTS

REMOVAL

1. REMOVE SEAT TRACK COVERS
Using a screwdriver, remove the seat track covers.

HINT: Tape the screwdriver tip before use.

2. REMOVE FRONT SEAT
a. Remove the 4 bolts.
b. Disconnect the connectors.
c. Disconnect the airbag connector.

NOTE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.

d. Remove the front seat.

NOTE: Be careful not to damage the body.

INSTALLATION

1. INSTALL FRONT SEAT
a. Slide the front seat to the rearmost position.

NOTE: Make sure that seat adjuster locks.

b. Without holding the seat track handle, mount the seat to the vehicle.

NOTE: Be careful not to damage the body.

HINT: If holding the seat track handle, the adjuster rearmost position slip off.

c. Tighten the bolts on the front side temporarily, starting from the bolt on the inner side tighten them completely.

Torque: 37 N.m (380 kg.cm, 27 ft.lb)

d. Slide the front seat to the most front position.
e. Tighten the bolts on the rear side temporarily, starting from the bolt on the inner side tighten them completely.

Torque: 37 N.m (380 kg.cm, 27 ft.lb)

2. INSTALL SEAT TRACK COVERS