Canada - Headlight High Beam Indicator Light - Inoperative

Bulletin
0996

Issue Date
2001-09-28

Reference
BE-01-011

Model
Sequoia

Year Range
2001

Market
Canada

Component
BE

Subject:
HIGH BEAM INDICATOR LIGHT INOPERATIVE

In rare cases, some owners of 2001 model year Sequoia vehicles equipped with Daytime Running Lights (DRLs) may experience a condition in which the High Beam Indicator Light does not illuminate when the high beams are turned on. A modification to the wiring harness and replacement of the Body ECU, as described below, should be performed to correct this condition.

APPLICABLE VEHICLES:
2001 model year Sequoia vehicles with Daytime Running Lights (DRLs).





PRODUCTION CHANGE INFORMATION:





PARTS INFORMATION:

REPAIR PROCEDURE:

1. Modify the high beam indicator circuit wiring.
A. Remove the Combination Meter. See the 2001 Sequoia Repair Manual.
B. Locate connector C7 at the back of the combination meter.





C. Remove pin 11 (red and green wire) from the back of the connector.
D. To protect the terminal end, insert Pin 11 into the 2-pin connector (P/N 90980-11918) and verify pin tightness.





E. Tape the connector to the harness as shown.
F. Reinstall the combination meter.

2. Replace the Multiplex Computer (Body ECU), P/N 89221-OC020.
3. Verify proper system operation.





REPAIR TIME:

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.