Headlight High Beam Indicator Light - Inoperative
ELECTRICALEL007-01
September 7, 2001
Title:
HIGH BEAM INDICATOR LIGHT INOPERATIVE
Models:
'01 Sequoia
Introduction
In rare cases, some owners of 2001 model year Sequoia vehicles equipped with Daytime Running Lights (DRLs) may experience a condition in which the High Beam Indicator Light does not illuminate when the high beams are turned on. A modification to the wiring harness and replacement of the Body ECU, as described below, should be performed to correct this condition.
Applicable Vehicles
^ 2001 model year Sequoia vehicles with Daytime Running Lights (DRLs).
Production Change Information
Parts Information
Warranty Information
Applicable Warranty*:
This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from the vehicle's in-service date.
* Warranty application is limited to correction of a problem based upon a customer's specific complaint.
Repair Procedure
1. Modify the high beam indicator circuit wiring.
A. Remove the Combination Meter. See page BO-88 in the 2001 Sequoia Repair Manual.
B. Locate connector C7 at the back of the combination meter.
C. Remove pin 11 (red and green wire) from the back of the connector.
D. To protect the terminal end, insert Pin 11 into the 2-pin connector (P/N 90980-11918) and verify pin tightness.
E. Tape the connector to the harness as shown.
F. Reinstall the combination meter.
2. Replace the Multiplex Computer (Body ECU), P/N 89221-OC020.
3. Verify proper system operation.