Operation CHARM: Car repair manuals for everyone.

Cruise Control System

CIRCUIT DESCRIPTION

DTC Detecting Condition:




The purpose of this circuit is to prevent the engine from stalling, while driving in lock-up condition, when brakes are suddenly applied.

When the brake pedal is operated, this switch sends a signal to ECM. Then the ECM cancels operation of the lock-up clutch while braking is in progress.

Wiring Diagram:






Steps 1 - 2:




Step 3:




INSPECTION PROCEDURE

CHECK FOR INTERMITTENT PROBLEMS

TOYOTA HAND-HELD TESTER only:
By putting the vehicle's ECM in check mode, 1 trip detection logic is possible instead of 2 trip detection logic and sensitivity to detect open circuits is increased. This makes it easier to detect intermittent problems.
1. Clear the DTC.
2. Set the check mode.
3. Perform a simulation test.
4. Check the connector and terminal.
5. Handle the connector.