Component Tests and General Diagnostics

INSPECTION

Driver's Switch:

Passenger's Switch (Window Unlock):

Passenger's Switch : Window Lock:

1. 2 Door:
INSPECT POWER WINDOW MASTER SWITCH CONTINUITY
If continuity is not as specified, replace the switch.

Driver's Switch:

Front Passenger's Switch (Window Unlock):

Front Passenger's Switch (Window lock):

Rear Left Switch (Window Unlock):

Rear Left Switch (Window lock):

Rear Right Switch (Window Unlock):

Rear Right Switch (Window lock):

2. 4 Door:
INSPECT POWER WINDOW MASTER SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







3. INSPECT FRONT POWER WINDOW CONTROL SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







4. INSPECT REAR POWER WINDOW CONTROL SWITCH CONTINUITY
If continuity is not as specified, replace the switch.




5. Driver's side:
INSPECT POWER WINDOW MOTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 2 and negative (-) lead to terminal 1. Check that the motor turns clockwise.
b. Reverse the polarity, check that the motor turns counterclockwise.
If operation is not as specified, replace the motor.




6. Front passenger's side:
INSPECT POWER WINDOW MOTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 2 and negative (-) lead to terminal 1. Check that the motor turns clockwise.
b. Reverse the polarity, check that the motor turns counterclockwise.
If operation is not as specified, replace the motor.




7. Rear LH side:
INSPECT POWER WINDOW MOTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 1 and negative (-) lead to terminal 2. Check that the motor turns clockwise.
b. Reverse the polarity, check that the motor turns counterclockwise.
If operation is not as specified, replace the motor.




8. Rear RH side:
INSPECT POWER WINDOW MOTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 2 and negative (-) lead to terminal 1. Check that the motor turns clockwise.
b. Reverse the polarity, check that the motor turns counterclockwise.
If operation is not as specified, replace the motor.

9. 2 door:
INSPECT CIRCUIT BREAKER OPERATION




a. Disconnect the connector from the master switch.
b. Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 4 on the wire harness side connector, and raise the window to full closed position.




c. Continue to apply voltage and check that there is a circuit breaker operation noise within approximately 4 - 40 seconds.
d. Reverse the polarity and check that the window begins to descend within approximately 60 seconds.
If operation is not as specified, replace the motor.

10. 4 door:
INSPECT CIRCUIT BREAKER OPERATION




a. Disconnect the connector from the master switch.
b. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 5 on the wire harness side connector, and raise the window to full closed position.




c. Continue to apply voltage and check that there is a circuit breaker operation noise within approximately 4 - 40 seconds.
d. Reverse the polarity and check that the window begins to descend within approximately 60 seconds.
If operation is not as specified, replace the motor.







11. INSPECT POWER MAIN (Marking : PWR) RELAY CONTINUITY
If continuity is not as specified, replace the relay.