Spark Plug: Testing and Inspection
ON-VEHICLE INSPECTIONNOTE: "Cold" and "Hot" in these sentences express the temperature of the coils themselves. "Cold" is from -10 °C (14 °F) to 50 °C (122 °F) and "Hot" is from 50 °C (122 °F) to 100 °C (212 °F).
INSPECT SPARK PLUGS
a. Remove the ignition coils (with igniter).
b. Using a 16 mm plug wrench, remove the spark plugs.
c. Clean the spark plugs.
If the electrode has traces of wet carbon, allow it to dry and then clean with a spark plug cleaner.
Air pressure: Below 588 kPa (6 kgf/sq.cm, 85 psi)
Duration: 20 seconds or less
HINT: If there are traces of oil, remove it with gasoline before using the spark plug cleaner.
Recommended Spark Plug:
d. Check the spark plug for thread damage and insulator damage.
If abnormal, replace the spark plug.
e. Adjust the spark plug electrode gap.
Electrode gap: 0.8 mm (0.031 in.)
f. Using a 16 mm plug wrench, install the spark plugs.
Torque: 17.5 N.m (180 kgf.cm, 13 ft.lbf)
g. Reinstall the ignition coils (with igniter).