Rear Differential

REMOVAL
1. DRAIN HYPOID GEAR OIL
2. REMOVE REAR AXLE SHAFTS
3. DISCONNECT REAR PROPELLER SHAFT
2WD: See Propeller Shaft; Service and Repair.
4WD: See Propeller Shaft; Service and Repair.





4. REMOVE DIFFERENTIAL CARRIER ASSEMBLY
a. Remove the 10 nuts, washers and differential carrier assembly.

NOTICE: Be careful not to damage the installation surface.

b. Remove the gasket.

INSTALLATION
1. INSTALL DIFFERENTIAL CARRIER ASSEMBLY
a. Install a new gasket.
b. Install the differential carrier assembly with 10 washers and nuts.

NOTICE: Be careful not to damage the installation surface.

Torque: 73 Nm (740 kgf-cm, 54 ft. lbs.)
2. CONNECT REAR PROPELLER SHAFT
2WD: See Propeller Shaft; Service and Repair.
4WD: See Propeller Shaft; Service and Repair.
3. INSTALL REAR AXLE SHAFTS
4. FILL DIFFERENTIAL WITH HYPOID GEAR OIL