Confirmation Driving Pattern

Wiring Diagram:

CONFIRMATION DRIVING PATTERN

Confirmation Driving Pattern:

a. Connect the TOYOTA hand-held tester to the DLC3.
b. Switch the TOYOTA hand-held tester from the normal mode to the check mode.
c. Start the engine and warm it up with all the accessory switched OFF.
d. Drive the vehicle at 60 - 120 km/h (38 - 75 mph) and the engine speed at 1,600 - 3,200 rpm for 3 - 5 minutes.

HINT: If a malfunction exists, the MIL will light up during step (d).

NOTE:
- If the conditions in this test are not strictly followed, detection of the malfunction will not be possible.
- If you do not have a TOYOTA hand-held tester, turn the ignition switch OFF after performing steps (c) and (d), then perform steps (c) and (d) again.

Wiring Diagram:

CONFIRMATION DRIVING PATTERN
a. Connect the TOYOTA hand-held tester or OBD II scan tool.
b. Record DTC and the freeze frame data.
c. Use the TOYOTA hand-held tester to set to the Check Mode.
d. Drive the vehicle several times with the engine speed, load and its surrounding range shown with ENGINE SPD, CALC LOAD in the freeze frame data or MISFIRE RPM, MISFIRE LOAD in the data list.
If you have no TOYOTA hand-held tester, turn the ignition switch OFF after the symptom is simulated the first time. Then repeat the simulation process again.