Troubleshooting
P0136 - Heated Oxygen Sensor Circuit Malfunction (Bank 1 Sensor 2)CIRCUIT DESCRIPTION
DTC Detecting Condition:
To obtain a high purification rate for the CO, HC and NOx components of the exhaust gas, a three-way catalytic converter is used, but for the most efficient use of the three-way catalytic converter, the air-fuel ratio must be precisely controlled so that it is always close to the stoichiometric air-fuel ratio.
The oxygen sensor has the characteristic whereby its output voltage changes suddenly in the vicinity of the stoichiometric air-fuel ratio. This is used to detect the oxygen concentration in the exhaust gas and provide feedback to the computer for control of the air-fuel ratio.
When the air-fuel ratio becomes LEAN, the oxygen concentration in the exhaust increases and the oxygen sensor informs the engine ECU of the LEAN condition (small electromotive force: <0.45 V).
When the air-fuel ratio is RICHER than the stoichiometric air-fuel ratio the oxygen concentration in the exhaust gas is reduced and the oxygen sensor informs the engine ECU of the RICH condition (large electromotive force: > 0.45 V). The engine ECU judges by the electromotive force from the oxygen sensor whether the air-fuel ratio is RICH or LEAN and controls the injection time accordingly. However, if malfunction of the oxygen sensor causes output of abnormal electromotive force, the engine ECU is unable to perform accurate air-fuel ratio control.
The main heated oxygen sensors include a heater which heats the zirconia element. The heater is controlled by the engine ECU. When the intake air volume is low (the temperature of the exhaust gas is low) current flows to the heater to heat the sensor for accurate oxygen concentration detection.
HINT:
- After confirming DTC P0125, use the OBDII scan tool or TOYOTA hand-held tester to confirm voltage output of the A/F sensor (bank 1, 2 sensor 1) from the CURRENT DATA.
- The ECM controls the voltage of the AFR+, AFL+, AFR- and AFL- terminals of the ECM to the fixed voltage. Therefore, it is impossible to confirm the A/F sensor output voltage without the OBDII scan tool or TOYOTA hand-held tester.
- OBDII scan tool (excluding TOYOTA hand-held tester) displays the one fifth of the A/F sensor output voltage which is displayed on the TOYOTA hand-held tester.
HINT:
After confirming DTC P0125/91, use the hand-held tester to confirm voltage output of the heated oxygen sensor (bank 1 sensor 2) from the CURRENT DATA.
If voltage output of the oxygen sensor (bank 1 sensor 2)is less than 0.1 V, oxygen sensor (bank 1 sensor 2) circuit may be open or short.
CONFIRMATION DRIVING PATTERN
HINT: If a malfunction exists, the check engine warning light comes on.
NOTE: If the conditions on this test are not strictly followed, the malfunction will not be detected.
Wiring Diagram:
Step 1:
Step 2 - 3:
INSPECTION PROCEDURE
NOTE: If the vehicle run out of fuel, the air-fuel ratio becomes LEAN and DTC P0125/91 will be recorded, and the check engine warning light then comes on.
HINT: Read freeze frame data using hand-held tester. Because freeze frame records the engine conditions when the malfunction is detected, when troubleshooting it is useful for determining whether the vehicle was running or stopped, the engine warmed up or not, the air-fuel ratio lean or rich, etc. at the time of the malfunction.
CHECK FOR INTERMITTENT PROBLEMS
TOYOTA hand-held tester only:
By putting the vehicle's ECM in the check mode, 1 trip detection logic is possible instead of 2 trip detection logic and sensitivity to detect open circuits is increased. This makes it easier to detect intermittent problems.
1. Clear the DTC
2. Set the check mode
3. Perform a simulation test.
4. Check the connector and terminal.
5. Handle the connector.