Rear Axle Hub & Bearing LH
REPLACEMENTHINT: Replace the RH side by the same procedures with the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSY, LH
a. Remove the bolt and separate the flexible hose.
b. Remove the 2 bolts and brake caliper.
c. Support the brake caliper securely.
3. REMOVE DISC, RR
4. SEPARATE WIRE, SKID CONTROL SENSOR
a. Disconnect the connector.
5. REMOVE HUB & BRG ASSY, RR AXLE W/ABS SENSOR, LH
a. Remove the 4 bolts and axle hub.
6. REMOVE SENSOR, SKID CONTROL
7. INSTALL SENSOR, SKID CONTROL
8. INSTALL HUB & BRG ASSY, RR AXLE W/ABS SENSOR, LH
a. Install the axle hub with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59 ft. lbs.)
9. INSTALL WIRE, SKID CONTROL SENSOR
a. Connect the connector.
10. INSPECT BEARING BACKLASH
a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
11. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
12. INSTALL DISC, RR
13. INSTALL REAR DISC BRAKE CALIPER ASSY, LH
a. Install the brake caliper with the 2 bolts.
Torque: 61.8 Nm (630 kgf-cm, 46 ft. lbs.)
b. Install the flexible hose with the bolt.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
15. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
16. CHECK ABS SPEED SENSOR SIGNAL