Camshaft Bearing

INSTALL CAMSHAFT
a. Tighten camshaft bearing cap No. 1 and No. 3 as the sequence shown in the illustration.
Torque:
Bearing cap No. 1 30 Nm (301 kgf-cm, 22 ft. lbs.)
Bearing cap No. 3 9 Nm (92 kgf-cm, 80 inch lbs.)

NOTICE:
- Tighten the bolts after deciding the position for the thrust direction of the camshaft by bearing cap No. 1.
- Install the camshaft with its timing mark of camshaft timing gear on top.





INSTALL NO. 2 CAMSHAFT
a. Tighten camshaft bearing cap No. 2 and No. 3 as the sequence shown in the illustration.
Torque:
Bearing cap No. 2 30 Nm (301 kgf-cm, 22 ft. lbs.)
Bearing cap No. 3 9 Nm (92 kgf-cm, 80 inch lbs.)

NOTICE:
- Tighten the bolts after deciding the position for the thrust direction of the camshaft by bearing cap No. 2.
- Install the camshaft with its timing mark of camshaft timing gear on top.