Symptom Related Diagnostic Procedures
PROBLEM SYMPTOMS TABLEIf a normal code is displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table and proceed to the relevant troubleshooting.
Problem Symptoms Table Part 1:
Problem Symptoms Table Part 2:
NOTE:
- When replacing skid control ECU, sensor or etc., turn the ignition switch OFF.
When replacing steering angle, master cylinder pressure, yaw rate, deceleration sensors on and the ECU, make sure to perform steering angle, master cylinder pressure, yaw rate, deceleration sensors zero point calibration. Component Tests and General Diagnostics