Rear

REPLACEMENT
1. REMOVE REAR WHEEL





2. REMOVE BRAKE CALIPER AND DISC
a. Remove the 2 bolts, brake caliper and disc.
b. Support the brake caliper securely.
3. REMOVE HUB BOLT





4. INSTALL HUB BOLT
Install a washer and nut to a new hub bolt, as shown in the illustration. Install the hub bolt by torquing the nut, while holding the axle shaft using a brass bar or an equivalent.
5. INSTALL DISC AND BRAKE CALIPER
Install the disc and brake caliper with the 2 bolts.
Torque: 105 Nm (1,070 kgf-cm, 77 ft. lbs.)
6. INSTALL REAR WHEEL
Torque: 110 Nm (1,150 kgf-cm, 83 ft. lbs.)