Transmission Control System
P1520 - Stop Light Switch Circuit MalfunctionCIRCUIT DESCRIPTION
DTC Detection Condition:
The purpose of this circuit is to prevent the engine from stalling, while driving in lock-up condition, when brakes are suddenly applied.
When the brake pedal is depressed, this switch sends a signal to ECM. Then the ECM cancels operation of the lock-up clutch while braking is in progress.
Wiring Diagram:
Step 1 - 3:
Step 3(continued):
INSPECTION PROCEDURE
CHECK FOR INTERMITTENT PROBLEMS
HINT:
Hand-held tester only:
By putting the vehicle's ECM in check mode, 1 trip detection logic is possible instead of 2 trip detection logic and sensitivity to detect open circuits is increased. This makes it easier to detect intermittent problems.
a. Clear the DTCs.
b. Set the check mode.
c. Perform a simulation test.
d. Check the connector and terminal.
e. Handle the connector.