Operation CHARM: Car repair manuals for everyone.

Ignition Cable: Testing and Inspection

ON-VEHICLE INSPECTION

NOTE: "Cold" and "Hot" in these sentences express the temperature of the coils themselves. "Cold" is from -10 °C (14 °F) to 50 °C (122 °F) and "Hot" is from 50 °C (122 °F) to 100 °C (212 °F).

INSPECT HIGH-TENSION CORDS




a. Remove the air cleaner hose.

b. Disconnect the high-tension cords at the rubber boot.
Do not pull on the high-tension cords.

NOTE: Pulling on or bending the cords may damage the conductor inside.




c. Using an ohmmeter, measure the high-tension cord resistance.

Maximum resistance: 25 kOhms per cord

If the resistance is greater than maximum, check the terminals.
If necessary, replace the high-tension cord.




d. Reconnect and install the high-tension cords as shown in the illustration.