Operation CHARM: Car repair manuals for everyone.

Engine Control System

DTC P0571 Brake Switch "A" Circuit

CIRCUIT DESCRIPTION

DTC Detection Condition:




This signal is used to detect when the brakes have been applied. The STP signal voltage is the same as the voltage supplied to the stop lights.

The STP signal is used mainly to control the fuel cut-off engine speed (The fuel cut-off engine speed is reduced slightly when the vehicle is braking.).

Wiring Diagram:






INSPECTION PROCEDURE

HINT: Read freeze frame data using the hand-held tester or the OBD II scan tool, as freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air-fuel ratio was lean or rich, etc. at the time of the malfunction.

Step 1 - 3:




Step 4:




Hand-held tester:

Step 1 - 2:




Step 3 - 4:




OBD II scan tool (excluding hand-held tester):