Air Bag Control Module: Service and Repair

Air Bag Sensor Assy Center:

REPLACEMENT
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSY
4. REMOVE CONSOLE PANEL SUB-ASSY UPPER
5. REMOVE CONSOLE UPPER PANEL GARNISH NO.1
6. REMOVE CONSOLE UPPER PANEL GARNISH NO.2
7. REMOVE CONSOLE BOX ASSY REAR
8. REMOVE CONSOLE BOX MOUNTING BRACKET FRONT
9. REMOVE CONSOLE BOX DUCT NO.1




10. REMOVE AIR BAG SENSOR ASSY CENTER
a. Disconnect the 3 connectors from the air bag sensor assy center.
b. Remove the 3 bolts and airbag sensor assy center.

11. INSPECT AIR BAG SENSOR ASSY CENTER

12. INSTALL AIR BAG SENSOR ASSY CENTER
a. Check that the ignition switch turn OFF.
b. Check that the battery negative terminal is disconnected.

NOTE: Do not start the operation for 90 seconds after removing the terminal.

c. Temporarily install the air bag sensor assy center with the 3 bolts.
d. Tighten the 3 bolts to the specified torque.

Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)

e. Connect the connector to the air bag sensor assy center.
1. Check that no play is identified.

g. Check that the water-proof sheet is properly set.

13. INSPECT SRS WARNING LIGHT