Navigation System

DIAGNOSTIC TROUBLE CODE CHARTS

Logical address: 01 (Communication control) 1 Of 2:

Logical address: 01 (Communication control) 2 Of 2:

Logical address: 21 (Switch):

Logical address: 61 (Cassette tape player):

Logical address: 62 (CD player):

RADIO RECEIVER ASSY (Physical address: 140)
* 1 Even it no failure is detected, this code may be stored depending on the battery condition or voltage for starting an engine.
* 2 This code is stored when 180 sec. has passed after the power supply connector is pulled out after engine start.
* 3 This code may be stored when the engine key is turned again after engine start.
* 4 This code may be stored when the engine key is turned again 1 min. after engine start.

Logical address: 01 (Communication control) 1 Of 2:

Logical address: 01 (Communication control) 2 Of 2:

Logical address: 58 (Navigation ECU):

Logical address: 80 (GPS receiver) 1 Of 2:

Logical address: 80 (GPS receiver) 2 Of 2:

NAVIGATION ECU (Physical address: 178)
* 1 Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting the engine.
* 2 When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.
* 3 This code may be stored when the engine key is turned 1 min. again after engine start.
* 4 This code may be stored when the engine key is turned again after engine start.










DISK PLAYER ASSY (Physical address: 250)

Logical address: 01 (Communication control) 1 Of 2:

Logical address: 01 (Communication control) 2 Of 2:

STEREO COMPONENT AMPLIFIER ASSY (Physical address: 440)
* 1 Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting an engine.
* 2 This code be stored when the engine key is turned again 1 min. after engine start.
* 3 This code may be stored when the engine key is turned again after engine start.
* 4 When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.

Logical address: 01 (Communication control) 1 Of 2:

Logical address: 01 (Communication control) 2 Of 2:

STEREO COMPONENT CONTROLLER ASSY
* 1 Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting an engine.
* 2 This code be stored when the engine key is turned again 1 min. after engine start.
* 3 This code may be stored when the engine key is turned again after engine start.
* 4 When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.