Transmission Position Sensor/Switch: Service and Repair
REPLACEMENT1. REMOVE COVER, ENGINE UNDER, No.2
2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSY
a. Pry off the lock washer and remove the nut.
b. Remove the bolt and park/neutral position switch
4. INSTALL PARK/NEUTRAL POSITION SWITCH ASSY
a. Install the park/neutral position switch with bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
b. Install a new lock washer and nut.
Torque: 7 Nm (71 kgf-cm, 62 inch lbs.)
c. Bent the claws on the lock washer to stake the nut.
d. Adjust the park/neutral position switch.
5. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
6. INSTALL COVER, ENGINE UNDER, No.2
7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSY