Actuator Check

PRE-CHECK

1. LIST OF OPERATION METHODS




By operating each of the A/C control switches as shown the diagram, it is possible to enter the diagnosis check mode.

2. INDICATOR CHECK




a. Turn the ignition switch ON while pressing the A/C control AUTO switch and R/F switch simultaneously.




b. Check that the indicators light up and go off at second intervals 4 times in succession.

HINT:
- After the indicator check is completed, the system enters the DTC begins automatically.
- Press the OFF switch when desiring to cancel the check mode.




ACTUATOR CHECK




a. After entering the DTC check mode (Sensor Check Mode) press the R/F switch.
b. Since each damper, motor and relay automatically operates at 1 second intervals beginning in order from 10 in the temperature display, check the temperature and air flow visually and by hand.

If the slower display is desired, press the FRONT DEF switch and change it to step operation. Each time the FRONT DEF switch is pressed, the display changes by 1 step.






HINT:
- Code are displayed in order from the smaller to the larger numbers.
- To cancel the check mode, press the OFF switch.