Pre-Check
PRE-CHECK1. OUTLINE OF THEFT DETERRENT SYSTEM
When the theft deterrent system is set and any of the following conditions is met, the system sounds the horns and flashes the headlights and the taillights for approximately 1 minute. At the same time, the system locks all the doors (If all the doors are not locked at once, the system repeats the door locking operation every 6.38 seconds during the 1-minute-alarming time).
There are 2 modes in this system; one is the active arming mode and another is the passive arming mode. The system is set initially in the active arming mode. It can be switched to the passive arming mode by a specified operation (See step 4).
- Any of the doors (including the engine hood and back door) is unlocked or opened without the key. *1
- The battery terminal is disconnected and reconnected.
- The system receives a panic signal from remote keyless entry. *2
*1: Only in the active arming mode.
*2: When the ignition key is not inserted in the key cylinder.
HINT: There are 4 states in each mode, which are disarmed state, arming preparation state, armed state and alarm sounding state.
1. Disarmed state:
- When a user is near the vehicle.
- When the alarming function does not operate.
- When the theft deterrent function does not operate.
2. Arming preparation state:
- Time from a user locks a door to leave the vehicle.
- Time until transferring to the armed state.
- When the theft deterrent function does not operate.
3. Armed state:
- When a user leaves the vehicle completely.
- When the theft deterrent function operates.
4. Alarm sounding state:
- In this condition, once a theft is detected, the lights will flash and the horns will sound to alert people around the vehicle to the theft.
Refer to the table for alarming method and time.
HINT: In the alarm sounding state, when either of the doors is unlocked and no key is in the key cylinder, the force lock signal is output.
2. ACTIVE ARMING MODE
Indicator light output
HINT: Even in the disarmed state, the indicator lamp flashes, due to a signal output from the immobilizer system.
And also, the indicator light flashes whenever receiving a signal from the immobilizer system at any time in the armed state.
Flashing frequency:
0.2 seconds (ON)
1.8 seconds (OFF)
3. PASSIVE ARMING MODE
- This mode can be switched according to the specified method (See step 4).
Part 1:
Part 2:
- The initially set mode (when shipped from factory) is the active arming mode (No passive arming mode).
Entry delay function
HINT: In the armed state, if any closed door is opened, entry delay time will start.
If the transferring condition (Armed state -> Disarmed state) is satisfied during this entry delay time, the system will transfer to the disarmed state. However if the condition is not satisfied, the system will judge it to be a theft, and then the system will transfer to the alarm sounding state.
HINT: The entry delay time can be selected among 0, 14, 30 seconds by the customizing function.
Indicator lamp output
HINT: Even in the disarmed state, the indicator lamp flashes, due to a signal output from the immobilizer system. And also, the indicator light flashes whenever receiving a signal from the immobilizer system at any time in the armed state.
Flashing frequency
0.2 seconds (ON)
1.8 seconds (OFF)
Transfer to the active arming mode
HINT: In each state of the passive arming mode, when the transferring condition to the active arming mode (disarmed state of active arming mode -> arming preparation state of active arming mode) is satisfied, the system will transfer to each state of the active arming mode. In this case, the active arming mode will continue until the system transfers to the disarmed state.