Speed Sensor, Rear
SPEED SENSOR REAR LHREPLACEMENT
HINT: Replace the RH side by the same procedure with LH side.
1. REMOVE RE R WHEEL
2. REMOVE REAR DOOR SCUFF PLATE OUTSIDE LH
3. REMOVE REAR FLOOR FINISH PLATE
4. REMOVE DECK TRIM SIDE PANEL ASSY LH
5. REMOVE SPEED SENSOR REAR LH
a. Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.
b. Remove the 2 clamp bolts holding the sensor harness from the body and shock absorber.
c. Remove the bolt and speed sensor rear LH.
NOTICE: Do not stick and foreign matter on the sensor tip.
6. INSTALL SPEED SENSOR REAR LH
a. Install the speed sensor rear LH with the bolt.
Torque: 20 Nm (205 kgf-cm, 15 ft. lbs.)
NOTICE: Do not stick and foreign matter on the sensor tip.
b. Install the sensor harness clamps with the 2 bolts to the body and shock absorber.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
c. Push in the sensor wire harness with grommet and connect the speed sensor connector.
7. INSTALL DECK TRIM SIDE PANEL ASSY LH
8. INSTALL REAR FLOOR FINISH PLATE
9. INSTALL REAR DOOR SCUFF PLATE OUTSIDE LH
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
11. CHECK ABS SPEED SENSOR SIGNAL