Blower Motor Linear Controller

BLOWER MOTOR LINEAR CONTROLLER (AUTO A/C)

INSPECTION

1. REMOVE LOWER NO.2 FINISH PANEL




2. REMOVE BLOWER MOTOR LINEAR CONTROLLER
a. Disconnect the connector.
b. Remove the 2 screws and blower motor linear controller.

3. INSPECT BLOWER MOTOR LINEAR CONTROLLER
Refer to diagnostic information provided at Heating and Air Conditioning; Testing and Inspection.
If resistance is not as specified, replace the blower resistor.

4. INSTALL BLOWER MOTOR LINEAR CONTROLLER
a. Install the blower motor linear controller with the 2 screws.
b. Connect the connector.

5. INSTALL LOWER NO.2 FINISH PANEL