Rear Wiper and Washer

REMOVAL




1. REMOVE WIPER ARM
Remove the nut, wiper arm and grommet.

2. REMOVE BACK DOOR ASSIST GRIP




a. Using a screwdriver, open the covers.

HINT: Tape the screwdriver tip before use.

b. Remove the 2 screws and assist grip.

3. REMOVE BACK DOOR PULL STRAP




a. Using a screwdriver, remove the strap cover.

HINT: Tape the screwdriver tip before use.

b. Remove the screw and back door pull strap.




4. REMOVE CENTER GARNISH
Using a screwdriver, remove the center garnish.

HINT: Tape the screwdriver tip before use.

5. REMOVE SIDE GARNISH




a. Using a screwdriver, remove the side garnish.

HINT: Tape the screwdriver tip before use.

b. Employ the same manner described above to the other side.

6. REMOVE BACK DOOR TRIM BOARD




a. Insert a screwdriver between the door and door trim board to pry the door trim board out.

NOTE: Be careful not to damage the door and door trim board.

HINT: Tape the screwdriver tip before use.

b. Pull the door trim board to remove it.

7. REMOVE WIPER MOTOR AND LINK ASSEMBLY




a. Remove the grommet.
b. Disconnect the connector.
c. Remove the 3 bolts from the wiper motor.
d. Remove the 2 bolts and wiper motor and link assembly.

INSTALLATION

1. INSTALL WASHER NOZZLE
2. INSTALL WIPER MOTOR AND LINK ASSEMBLY




a. Install the grommet.
b. Install the wiper motor and link assembly with 5 bolts.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

c. Connect the connector.




3. INSTALL BACK DOOR TRIM BOARD
Install the door trim board to the back door panel.

4. INSTALL SIDE GARNISH




a. Install the side garnish to the back door panel.
b. Employ the same manner described above to the other side.




5. INSTALL CENTER GARNISH
Install the center garnish to the back door panel.

6. INSTALL BACK DOOR PULL STRAP




a. Install the back door pull strap with the screw.
b. Install the strap cover.

7. INSTALL BACK DOOR ASSIST GRIP




a. Install the back door assist grip with the 2 screws.
b. Close the covers.

8. INSTALL WIPER ARM
a. Operate the wiper once and turn the wiper switch OFF.
b. Install the wiper arm and tighten nuts by hand.




c. Adjust the installation position of the wiper arm to the position shown in the illustration.

A: 38.6 mm (1.520 in.)

d. Torque the nut.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)