Pinout Values and Diagnostic Parameters
TERMINALS OF ECU1. CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSY (BODY ECU)
Terminals Of ECM/Pinouts - Check Instrument Panel Junction Block Assy (Body ECU):
a. Disconnect the IB, IE, IF, IH, IK, IL, B4 and B6 J/B connectors, and check the voltage or continuity of each terminal of the vehicle side connectors.
If the result is not as specified, there may be a malfunction on the wire harness side.
b. Reconnect the J/B connectors IB, IE, IF, IH, IK, IL, B4 and B6, and check the voltage of each terminal of the connectors.
If the result is not as specified, the vehicle may be defective. In this case, check the harness, connector and fuse between the ECU and battery. Then repair or replace it if necessary.
Terminals Of ECM/Pinouts - Check Multiplex Network Door Ecu Back (Back Door ECU):
2. CHECK MULTIPLEX NETWORK DOOR ECU BACK (BACK DOOR ECU)