Without Scan Tool

DTC CLEARANCE (Not using a service wire)

When the ignition switch is turned off, the diagnostic trouble code is cleared.

HINT: Depending on the DTC, the code might not be cleared by turning the ignition switch OFF. In this case, proceed to the next step.

DTC CLEARANCE (Using a service wire)

a. Using SST, connect the terminal TC and terminal CG of the DLC3.
SST 09084-18040
b. Disconnect the terminal TC of DLC3 within 10 seconds after the DTCs appear, and check if the warning light comes on within 3.0 seconds.
c. Within 2.0 seconds to 4.0 seconds after the SRS warning light comes on, re-connect the terminal TC and terminal CG of the DLC3.
d. The SRS warning light goes off 3.0 seconds after re-connecting the terminal TC and terminal CG of the DLC3. Then disconnect the terminal TC of the DLC3 within 2.0 to 4.0 seconds after the SRS warning light goes off.
e. The SRS warning light comes on within 3.0 seconds after re-disconnecting the terminal TC and terminal CG of the DLC3.
f. Within 2.0 seconds to 4.0 seconds after the SRS warning light comes on, re-connect the terminal TC and terminal CG of the DLC3.
g. The SRS warning light goes off 3.0 seconds after reconnecting the terminal TC and terminal CG of the DLC3.
h. A normal code appears 1.0 second after the SRS warning light goes off.




If DTCs are not cleared, repeat the procedure until the codes are cleared.