Speed Sensor, Front
SPEED SENSOR FRONT LHREPLACEMENT
HINT: Replacement of RH side is same as that of LH side.
1. REMOVE FRONT WHEEL
2. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the speed sensor connector.
b. Using a hexagon wrench (5 mm), remove the bolt and front speed sensor from the steering knuckle.
NOTICE:
^ Do not stick and foreign matter on the sensor tip.
^ Do not let the foreign matter into the sensor installation hole.
3. INSTALL SPEED SENSOR FRONT LH
a. Using a hexagon wrench (5 mm), install the front speed sensor with the bolt to the steering knuckle.
Torque: 8.3 Nm (85 kgf-cm, 73 inch lbs.)
NOTICE: Make sure the sensor tip is clean.
b. Connect the speed sensor connector.
4. INSTALL FRONT WHEEL
Torque: 110 Nm (1,122 kgf-cm, 81 ft. lbs.)
5. CHECK VSC SENSOR SIGNAL