Engine Control Module: Service and Repair
REPLACEMENT1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH
3. REMOVE COWL SIDE TRIM SUB-ASSY RH
4. REMOVE GLOVE COMPARTMENT DOOR ASSY
5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2
6. REMOVE ECM
a. Remove the 2 wire harness clamps.
b. Disconnect the 5 ECM connectors.
c. Remove the 2 nuts and ECM.
7. REMOVE ECM BRACKET NO. 1
a. Remove the 2 screws and ECM bracket.
8. REMOVE ECM BRACKET NO. 2
a. Remove the 2 screws and ECM bracket.
9. INSTALL ECM BRACKET NO. 2
a. Install the ECM bracket with the 2 screws.
10. INSTALL ECM BRACKET NO. 1
a. Install the ECM bracket with the 2 screws.
11. INSTALL ECM
a. Install the 2 wire harness clamps.
c. Connect the 5 ECM connectors.
c. Install the ECM with the 2 nuts.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER NO.2
13. INSTALL GLOVE COMPARTMENT DOOR ASSY
14. INSTALL COWL SIDE TRIM SUB-ASSY RH
15. INSTALL FRONT DOOR SCUFF PLATE RH
16. CONNECT BATTERY NEGATIVE TERMINAL