Cylinder Block Assembly: Specifications

Exploded View





INSTALL STUD BOLT
Install the stud bolts as shown in the illustration.
Torque:
5.0 Nm (51 kgf-cm, 44 inch lbs.) for stud bolt A
10 Nm (102 kgf-cm, 7 ft. lbs) for stud bolt B
5.0 Nm (51 kgf-cm, 44 inch lbs.) for stud bolt C





Install and uniformly tighten 10 main bearing cap bolts in several passes, in the sequence shown.
Torque 40 Nm (408 kgf-cm, 30 ft. lbs.)

INSPECT CYLINDER BORE
Using a cylinder gauge, measure the cylinder bore diameter at positions A and B in the thrust and axial directions.
Standard diameter 88.500 to 88.513 mm (3.4842 to 3.4848 inch)
Maximum diameter 88.633 mm (3.4895 inch)

INSPECT PISTON CLEARANCE
Subtract the piston diameter measurement from the cylinder bore diameter measurement.
Specified oil clearance 0.051 to 0.100 mm (0.0020 to 0.0039 inch)

INSPECT CYLINDER BORE
Using a cylinder gauge, measure the cylinder bore diameter at positions A and B in the thrust and axial directions.
Specified diameter 92.000 to 92.132 mm (3.6220 to 3.6272 inch)