Speed Sensor, Rear
SPEED SENSOR REAR LHREPLACEMENT
HINT: Replace the RH side by using the same procedures as those for the LH side.
1. REMOVE DECK SIDE TRIM COVER LH
2. REMOVE REAR WHEEL
3. REMOVE SPEED SENSOR REAR LH
a. Disconnect the speed sensor connector.
NOTICE: Be careful not to damage the wire harness.
b. Pull out the sensor wire harness with the grommet
NOTICE: Do not pull sensor wire.
c. Remove the 2 bolts holding the sensor harness from the body and the shock absorber assy.
d. Remove the bolt and the speed sensor rear.
NOTICE: Prevent foreign matter from attaching to the sensor tip.
4. INSTALL SPEED SENSOR REAR LH
a. Install the speed sensor rear with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: Prevent foreign matter from attaching to the sensor tip.
b. Install the sensor harness clamps with the 2 bolts to the body and the shock absorber assy.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
NOTICE: Do not twist the sensor wire when instilling the sensor.
c. Push in the sensor wire harness with grommet.
NOTICE: When grommet is set to body, pull the grommet do not pull sensor wire.
d. Connect the speed sensor connector.
5. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
6. INSTALL DECK SIDE TRIM COVER LH
7. CHECK ABS SPEED SENSOR SIGNAL