Rear

INSPECT DISC THICKNESS
Using a micrometer, measure the disc thickness.
Standard thickness: 10.0 mm (0.394 inch)
Minimum thickness: 8.5 mm (0.335 inch)






INSPECT DISC RUNOUT
a. Temporarily fasten the rear disc with hub nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
b. Using a dial gauge, measure the disc runout 10 mm (0.39 inch)away from the outer edge of the rear disc.
Maximum disc runout: 0.15 mm (0.0059 inch)
c. If the disc runout is equal to maximum value or greater, check the bearing play in the axial direction and check the axle hub runout. If the bearing play and axle hub runout are not abnormal, adjust the disc runout or grind it on a "On-car" brake lathe.