Outer Rear View Mirror Assembly LH

REPLACEMENT

HINT:
- The Installation is in the reverse order of the removal. However, when there is a special point concerning the installation, it is indicated.
- On the RH side, use the same procedures as on the LH side.

1. REMOVE FRONT DOOR SERVICE HOLE COVER LH
a. Remove the front door lower frame bracket garnish LH.
b. Remove the front door inside handle bezel LH.
c. Remove the front armrest assembly LH.
d. Remove the front door trim board LH.
e. Remove the front door service hole cover LH.




2. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
a. Disconnect the connector.
b. Remove the 3 nuts and mirror.




3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
a. Install the mirror with the 3 nuts.

Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

b. Connect the connector.