Fuel Pump Control Circuit
FUEL PUMP CONTROL CIRCUITCIRCUIT DESCRIPTION
In the diagram, when the engine is cranked, current flows from terminal STAR of the ECM to the starter relay coil and also current flows to terminal STA of the ECM (STA signal).
When the STA signal and NE signal are input to the ECM, the Tr1 is turned ON, current flows to the coil of the circuit opening relay, the relay switches on, power is supplied to the fuel pump, and the fuel pump operates.
While the NE signal is generated (engine running), the ECM keeps the Tr1 ON (circuit opening relay ON) and the fuel pump also keeps operating.
The fuel pump speed is controlled at two levels (high speed or low speed) by the engine condition (starting, light load, heavy load). When the engine starts (STA ON), the Tr2 in the ECM is OFF, so the fuel pump relay closes and battery positive voltage is applied directly to the fuel pump. The fuel pump operates at high speed.
After the engine starts during idling or light loads, since the Tr2 goes ON, power is supplied to the fuel pump via the fuel pump resistor. The fuel pump operates at low speed.
HINT: This DTC chart is on the premise that the engine is started. If the engine is not started, proceed to the problem symptoms table.
Wiring Diagram:
INSPECTION PROCEDURE
Step 1 - 3:
Step 4 - 6:
Step 7:
Step 8:
Step 9 - 10:
Step 11:
Step 12:
Hand-held tester: