Transmission Position Sensor/Switch: Service and Repair
REPLACEMENT1. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO.1
2. REMOVE ENGINE UNDER COVER ASSEMBLY REAR
3. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Pry off the lock washer and remove the nut.
b. Remove the bolt and park/neutral position switch.
5. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Install the park/neutral position switch with bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
b. Install a new lock washer and nut.
Torque: 7 Nm (71 kgf-cm, 62 inch lbs.)
c. Bent the claws on the lock washer to stake the nut.
d. Adjust the park/neutral position switch.
6. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
7. INSTALL ENGINE UNDER COVER ASSEMBLY REAR
8. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.1
9. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY