Variable Valve Timing Actuator Position Sensor: Service and Repair
REPLACEMENT1. DRAIN ENGINE COOLANT
2. REMOVE V-BANK COVER
3. DISCONNECT VENTILATION HOSE NO.2
4. REMOVE AIR CLEANER ASSEMBLY
5. REMOVE VVT SENSOR
a. RH bank side VVT sensor.
1. Disconnect the VVT sensor connector.
2. Remove the bolt and the VVT sensor.
b. LH bank side VVT sensor.
1. Disconnect the water by-pass hoses No.4 and No. 5.
2. Disconnect the VVT sensor connector.
3. Remove the bolt and the VVT sensor.
6. INSTALL VVT SENSOR
a. LH bank side VVT sensor.
1. Apply a light coat of engine oil to an O-ring of the VVT sensor.
2. Install the VVT sensor with the bolt.
Torque: 8.0 Nm (82 kgf.cm, 71 in.lbf)
3. Connect the VVT sensor connector.
4. Connect the water by-pass hoses No.4 and No.5.
b. RH bank side VVT sensor.
1. Apply a light coat of engine oil to an O-ring of the VVT sensor.
2. Install the VVT sensor with the bolt.
Torque: 8.0 Nm (82 kgf.cm, 71 in.lbf)
3. Connect the VVT sensor connector.
7. INSTALL AIR CLEANER ASSEMBLY
8. CONNECT VENTILATION HOSE NO.2
9. ADD ENGINE COOLANT
10. CHECK FOR ENGINE COOLANT LEAKS
11. INSTALL V-BANK COVER
a. Install the V-bank cover with the 2 nuts.
Torque: 7.5 Nm (76 kgf.cm, 66 in.lbf)