Safing Sensor: Service and Repair

Air Bag Sensor Assy Center:

REPLACEMENT

1. PRECAUTION
Observe Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY
4. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER
5. REMOVE CONSOLE UPPER PANEL GARNISH NO.1
6. REMOVE CONSOLE UPPER PANEL GARNISH NO.2
7. REMOVE CONSOLE BOX ASSEMBLY REAR
8. REMOVE CONSOLE BOX MOUNTING BRACKET FRONT
9. REMOVE CONSOLE BOX DUCT NO.1




10. REMOVE AIR BAG SENSOR ASSEMBLY CENTER
a. Disconnect the 3 connectors from the air bag sensor assembly center.
b. Remove the 3 bolts and airbag sensor assembly center.

11. INSPECT AIR BAG SENSOR ASSEMBLY CENTER
12. INSTALL AIR BAG SENSOR ASSEMBLY CENTER
a. Check that the ignition switch turn OFF.
b. Check that the battery negative terminal is disconnected.

NOTE: Do not start the operation for 90 seconds after removing the terminal.

c. Temporarily install the air bag sensor assembly center with the 3 bolts.
d. Tighten the 3 bolts to the specified torque.

Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)

e. Connect the connector to the air bag sensor assembly center.
f. Check that no play is identified.
g. Check that the water-proof sheet is properly set.

13. INSPECT SRS WARNING LIGHT