System Inspection

INSPECTION

1. INSPECT FRONT DOOR W/ MOTOR LOCK ASSEMBLY LH




a. Apply battery voltage and inspect operation of the door lock motor.




Standard:

If operation is not as specified, replace the door lock assembly.




b. Inspect the door lock and unlock switch continuity.




Standard:

IF the continuity is not as specified, replace the door lock assembly.

c. Inspect the position switch continuity.




Standard:

If the continuity is not as specified, replace the door lock assembly.

2. INSPECT FRONT DOOR W/ MOTOR LOCK ASSEMBLY RH




a. Apply battery voltage and inspect operation of the door lock motor.




Standard:

If operation is not as specified, replace the door lock assembly.

3. INSPECT REAR DOOR W/MOTOR LOCK ASSEMBLY LH




a. Apply battery voltage and inspect operation of the door lock motor.




Standard:

If the operation is not as specified, replace the door lock assembly.

b. Inspect the position switch continuity.




Standard:

If the continuity is not as specified, replace the door lock assembly.

4. INSPECT REAR DOOR W/MOTOR LOCK ASSEMBLY RH




a. Apply battery voltage and inspect operation of the door lock motor.




Standard:

If operation is not as specified, replace the door lock assembly.

b. Inspect the position switch continuity.




Standard:

If the continuity is not as specified, replace the door lock assembly.

5. INSPECT W/MOTOR BACK DOOR LOCK ASSEMBLY




a. Check operation of the door lock.
1. Using a screwdriver, push the latch in order to put the back door lock in the locked condition (full-latch position).
2. Connect the positive (+) lead to terminal 1 and the negative (-) lead to terminal 2. Then, check operation of the latch.

Standard: The latch turns to the open-latch position

3. Inspect motor operation when battery voltage is applied to the terminals.




Standard:

If the operation is not as specified, replace the door lock assembly.




b. Check the back door courtesy switch continuity.
1. Check the continuity between the terminals of the courtesy switch.




Standard:

If the continuity is not as specified, replace the door lock assembly.

c. Check the back door latch switch continuity.
1. Check the continuity between the terminals of the latch switch.




Standard:

If the continuity is not as specified, replace the door lock assembly.

d. Check the position switch continuity.
1. Connect the battery positive (+) lead to connector terminal 1 and the negative (-) lead to connector terminal 2.




Standard:

If the continuity is not as specified, replace the door lock assembly.

6. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY




a. Inspect the door lock control switch continuity




Standard:

If the result is not as specified, replace the switch assembly.

7. INSPECT DOOR CONTROL SWITCH ASSEMBLY




a. Passenger side switch:
Inspect the door lock control switch continuity




Standard:

If the result is not as specified, replace the switch assembly.

8. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY




a. Inspect the back door opener switch continuity.




Standard:

If the result is not as specified, replace the switch assembly.